Nut Splitter

machine instructions for brick-making (concrete brick machine, brick free burning) servicing and maintenance

main supply line of devices should be used for more than 25 mm 2 16 mm 2 or more aluminum or copper. normal operation of the equipment when the input voltage: high voltage device 380V-410V, 330V-360V voltage, reliable grounding must be installed to ensure the safety of operators, such as the installation of earth are not necessary, which results in injury or death is not responsible for our factory.

Oil pump motor is stopped or running Bie difficult, resulting in burning engine, because the total pressure regulator device
Valve (large nut under the separator) controller is too big. (Total pressure regulator should be adjusted progressively smaller until the electrical work is not very difficult when the rotation is the best)

Vibrators is less vibration, a brick or a brick period of time lost because of the low pressure regulator die under pressure too, (under module pressure regulator too, the pressure of vibration suppression vibrating cylinder must be Next on the ejector tube pressure corresponding to a gradual transfer of regulation only to small, until the strength of the vibrations of the machine to fully play out)

Resulting in the mold arms balance, and host the site seems to weld or damage to the mold under pressure, under pressure regulator is too small (under pressure, under pressure regulator model is too small, pressure can not be locked into the mold, resulting Taiwan Mold and force of the impact of vibration is too large, throughout the damaged equipment that is too large, should be placed on the pipeline under ejector cylinder pressure corresponding to the regulations only adjust gradually until the force of vibration of the machine has been stabilized to reduce damage to the machine)

When the surface of tiles produced in bulk bricks, bricks are breaking phenomenon, or when the brick mold with the lower die of its own mention because of the pressure head pressure is too low (the pressure Head pressure too low will result in positioning bricks loose tile surface should be placed on the tube head pressure cylinder pressure corresponding to gradually adjust its own regulators Filed under great style, while in the gently moving the key to the model, which makes the tank head pressure to maintain a certain pressure depending on the model can be maintained in the slabs with the increase in mold, thereby reducing the rate of damage to a brick)

When the production of brick tiles found among the stomach because the pressure at the head of the cylinder pressure is too high, or the vibration time is too short, the model does not have to pressure (if found to be damaged bricks high, irregular, a model of care should pay attention to light when raised, or check the humidity and aggregates, as too wet, is presented as a brick when the brick is cut much water, too dry, is shown as brick deformed, can not a brick)

If the regulators fail, because of the pressure regulating valve spring damage or failure, (should be replaced the same type of pressure spring)

Cylinder leakage, as the fuel tank was found because of the loss of sealing cylinder body seal; (replaces the corresponding type of seal)

More emphasis on the use of maintenance equipment and maintenance to reduce maintenance, and therefore more qualified products.

Operation specific questions customers must read the instructions carefully, read after the implementation of the action, with the brick making machine (block machine, brick free burning) smooth and comfortable to use, bring into full play the superior equipment and extend its life.